The Ready LED will be turned on for 5 minutes, indicating that the system has been successfully connected to wifi. One must wait until the Ready LED on the computer indicates that the machine is connected.
The Toner LED, and the Drum LED will continue to blink all this time. If all goes well, the system can check for the wifi Protected Set-up access point/router.Note: It is necessary to remember that the button should not be pressed for more than 3 seconds or changed to the wifi Protected Setup mode PIN process.A pointy object should be used to press the button like a ballpoint pen. The wireless setup button must then be placed at the back of the unit and pressed down for less than 2 seconds.The time the button is kept will depend on the wifi connection point. Next, keep the WPS or the AOSS button for a few seconds on your WLAN control pointer or router.Next, make sure the wireless card is attached, and the computer is turned on until it is ready.Depending on the environment, however, the range can change. The Brother computer should be positioned within the range of the WPS or AOSS access point/router to configure wireless settings.To use wifi Protected Set Up or WPS, one should confirm whether the WLAN has a WPS access. The Brother machine can be easily connected to the wireless network if one has a WLAN access point or router that supports WPS or AOSS, also known as AirStation One-Touch Secure System. It’s pretty easy to connect the brother hl 2270dw printer to the wifi.
0 kommentar(er)
